Buy Low Price From Here Now
ZAL FN CNPS7000B-ALCU CPU 2-BALL heatsink w/ 92mm FN
Readmore
Technical Details
- 1. Does not generate noise or vibration in Silent Mode.- 2. Pure Copper and Pure Aluminum base materials ensure excellent heat dissipation.
- 3. Intel Pentium 4 (Socket 478), AMD Duron/Athlon/Athlon XP (Socket 462), and Sempron/AMD64 (Socket 754/939/940) compatible design for broad compatibility.(To use this product on socket 775, ZM-CS1 must be purchased separately.)
- 4. 92mm fan inside the FHS maximizes airflow and makes installation easier.
- 5. Adjustable fan speed controller (FAN MATE 2) enables control of noise and fan performance.
See more technical details
By genews (MO USA)
The Zalman fan, installed on an AMD socket 939 board, to replace a poorly fitting fan, dropped the routine CPU operating temperature from 46 C. to 34 C. Installation was quick and easy, taking approximately 15 minutes. The fan is fairly quiet, although not silent. I would definitely replace other fans with this fan.
By James Weister
great fan, sad to see it will not work for a socket 940, mounting plate and mount have 2 holes on each side, instructions say to pull motherboard and remove stock mount plate, but stock mounting plates have 4 holes on each corner not 2 in the middle, its a bad design for amd 940 boards.....
By Sneh Dalal
Great fan. It is rather large though. Almost didn't fit in my system. I like the speed control. Personally I wouldn't have to use it, but good to know it is there.
By Ehud Cohen
Very clear installation instructions, took me about 20min to remove the original fan and install this one. (used on Intel socket).
By K. King (Florida Panhandle)
I just installed this CPU cooler this afternoon after going on line and reading a few reviews. I have a 3.4GHz Pentium 4 on a socket 478 motherboard. It had been running hot (80 C and over according to the Everest computer status monitor) now that our weather has gotten warm. I checked that I had enough clearance around the processor socket, then installed the new cooler in about ten minutes. The steps for the socket 478 installation were: remove old fan and heat sink, replace the old thermal grease, slip two clip supports into the socket frame, put the new heat sink and fan in place and tighten two bolts. Then plug the fan controller intro the motherboard and the fan motor. That was all (the other socket types looked a little more complicated). Now under stress, the CPU temperature is running 20 C lower than with the original (budget type) fan and heat sink. I was amazed at how simple the installation was.
Images Product
Buy Zalman CNPS7000B-ALCU 92mm 2 Ball Cooling Fan Now
0 comments:
Post a Comment